Speedwerx M1 Metric Tube Die Sets

Speedwerx M1 Metric Tube Die Sets

Speedwerx Racing Products  manufacture a range of offer 250+ die sets for the M1 and M2 tube benders. Pricing is based on airfreighting the die sets  direct to NZ addresses  with a 12-21 day delivery expectation subject to any supply issues beyond our control. A smaller range of common die set sizes are held in stock in Auckland.

This range of die sets includes :

• Main die with with pivot block mount and clamp block mount to undertake upto 90° bends using the Speedwerx M1 Tube bender.
• Aluminium follow bar
• Clamp block
• Clamp block pin

All die sets can be used with a lubricant with Lucas White Lithium Grease an option.

Click here to view Speedwerx M1 bender die set installation
 

Important General Information

Please note tube and pipe are dimensioned differently and therefore require different die sets. Tubing is sized according to it's outside diameter (OD) and pipe is sized by it's nominal bore (NB) however the outside diameter must be known for correct die application.

Not all dies are suitable for bending aluminium or stainless steel, however all dies will bend chrome moly or mild steel. To determine material suitability, outside dimension and wall thickness, please refer to specifications for each size.

The Centre Line Radius is measured from the centre of the die to the centre of the tubing (tube, pipe).

Minimal wall thicknesses are a guide only.

M1 die sets also available for:

• Imperial tube die sets
• Metric tube die sets
• Nominal pipe bore die sets
• Square die sets