Speedwerx Racing Products manufacture a range of offer 250+ die sets for the M1 and M2 tube benders. Pricing is based on airfreighting the die sets direct to NZ addresses with a 12-21 day delivery expectation subject to any supply issues beyond our control. A smaller range of common die set sizes are held in stock in Auckland.
Please note tube and pipe are dimensioned differently and therefore require different die sets. Tubing is sized according to it's outside diameter (OD) and pipe is sized by it's nominal bore (NB) however the outside diameter must be known for correct die application.
Not all dies are suitable for bending aluminium or stainless steel, however all dies will bend chrome moly or mild steel. To determine material suitability, outside dimension and wall thickness, please refer to specifications for each size.
The Centre Line Radius is measured from the centre of the die to the centre of the tubing (tube, pipe).
Speedwerx Racing Products manufacture a range of offer 250+ die sets for the M1 and M2 tube benders. Pricing is based on airfreighting the die sets direct to NZ addresses with a 12-21 day delivery expectation subject to any supply issues beyond our control. A smaller range of common die set sizes are held in stock in Auckland.
This range of die sets includes main die, follow bar & clamp, main die wrap 120 degrees suitable for the Speedwerx M2 Tube bender. All die sets should be used with a lubricant with Lucas White Lithium Grease & Lucas Engine Assembly Lube two options.
Click here to view Speedwerx M2 bender die set installation
Important General Information
Please note tube and pipe are dimensioned differently and therefore require different die sets. Tubing is sized according to it's outside diameter (OD) and pipe is sized by it's nominal bore (NB) however the outside diameter must be known for correct die application.
Not all dies are suitable for bending aluminium or stainless steel, however all dies will bend chrome moly or mild steel. To determine material suitability, outside dimension and wall thickness, please refer to specifications for each size.
The Centre Line Radius is measured from the centre of the die to the centre of the tubing (tube, pipe).
Minimal wall thicknesses are a guide only.
M2 120° die sets also available for:
M2 240° die sets also available for: